Skip to main navigation menu Skip to main content Skip to site footer

Articles

Vol. 9 No. 3 (2022)

Anti-interference Strategy of 20-Hi Cold Mill Automatic Gauge Control

DOI
https://doi.org/10.15878/j.cnki.instrumentation.2022.03.003
Submitted
January 7, 2024
Published
2022-09-15

Abstract

Automatic gauge control (AGC in the article) is the key technology of product thickness accuracy and flatness quality in modern cold rolling mill. Most traditional AGC control algorithms need stable external system con-ditions and hard to stabilize under complex interference that meets coverage requirements. This paper presents a new anti-interference strategy for AGC control of 20-Hi cold reversing mill. The proposed algorithm intro-duces a united dynamic weights algorithm of feed forward-mass flow to avoid the complex interference problem in AGC control, the relevant control strategy is provided to eliminate the adverse effects. At the same time, the D-value between feed forward-mass flow pre-computation and thickness measurement deviation is dynamic compared, the final gap position regulation is calculated by developing a set of united dynamic weights between feed forward control and mass flow control. Finally, the output of controllers is sent to actuator though a constant rate smoothing. The proposed strategy is compared with conventional AGC control on Experimental platform and project application, the results show that the proposed strategy is more stable than comparison method and majority of system uncertainty produced by mentioned interference is significantly eliminated.

Downloads

Download data is not yet available.

Similar Articles

<< < 1 2 3 4 5 6 > >> 

You may also start an advanced similarity search for this article.